Intrusion Totally Explained

Everything about Intrusive totally explained

In geology, an intrusion is a body of igneous rock that has crystallized from molten magma below the surface of the Earth. Bodies of magma that solidify underground before they reach the surface of the earth are called plutons, named for Pluto, the Roman god of the underworld. Correspondingly, rocks of this kind are also referred to as igneous plutonic rocks or igneous intrusive rocks. This is to be contrasted with extrusive rocks. The rock surrounding a pluton is called country rock.

Varieties

In composition, intrusive rocks include the entire sequence of igneous rock types from the dense and dark ultramafic peridotites to the very light-colored and low-density alkali granites and syenites. A well-known example of an igneous intrusion is Devil's Tower in Wyoming, USA.

Structural types

Intrusive rocks also exist in a wide range of forms from mountain range sized batholiths to thin vein-like fracture fillings of aplite. Intrusive structures are often classified according to whether or not they're parallel to the bedding planes or foliation of the country rock: if the intrusion is parallel, the body is concordant, while if it cuts across the country rock, it's discordant. Structural types include:

batholith: large irregular discordant intrusions.
stock: smaller irregular discordant intrusions.
dike: a relatively narrow tabular discordant body, often with near-vertical attitude.
sill: a relatively thin tabular concordant body intruded along bedding planes, often near-horizontal when emplaced, but may be intruded into tilted beds or the entire package may be tilted by later deformation.
pipe or volcanic neck: circular or tube shaped nearly vertical body which may have been a feeder vent for a volcano.
laccolith: concordant body with essentially flat base and dome shaped upper surface, usually has a feeder pipe below.
lopolith: concordant body with a relatively flat to sagging top and a shallow covex base (spoon-shaped), may have a feeder dike or pipe below.
phacolith: a concordant lens-shaped pluton that typically occupies the crest of an anticline or the trough of a syncline.

Characteristics

Deep-seated intrusive rock formations are shown by the way in which they've burst through the superincumbent strata. The ramifying veins resulted from filled cracks. That they were at a very high temperature is equally clear from the changes that have been induced in the rocks that were in contact with them. But since heat can only dissipate slowly, and since the rock is under pressure, crystals form and no vitreous rapidly chilled matter is present. As they've had time to rest before crystallizing, they're not fluidal. Their contained gases have not been able to escape through the thick layer of strata, beneath which they were injected. Such gases form cavities, which can often be observed in these minerals. Such gases have also resulted in many important modifications in the crystallization of the rock. Because their crystals are of approximately equal size these rocks are said to be granular. There is typically no distinction between a first generation of large well-shaped crystals and a fine-grained ground-mass. Their minerals have formed, however, in a definite order, and each has had a period of crystallization which may be very distinct or may have coincided with or overlapped the period of formation of some of the other ingredients. The earlier crystals originated at a time when most of the rock was still liquid and are more or less perfect. The later crystals are less regular in shape because they were compelled to occupy the interspaces left between the already formed crystals. The former is said to be idiomorphic (or automorphic), the latter is anidiomorphic (allotriomorphic, xenomorphic). There are also many other characteristics which serve to distinguish the members of these two groups. Orthoclase, for example, is typically feldspar from granite, while its modifications occur in lavas of similar composition. The same distinction holds between elaeolite and nepheline. Leucite is common in lavas, but very rare in plutonic rocks. Muscovite is confined to the intrusions. These differences show the influence of the physical conditions under which consolidation takes place.
There is a certain class of intrusive rocks which have risen upwards towards the surface, but have failed to reach it, and have solidified in fissures as dikes and intrusive sills at no great depth. These types are given the name "intrusive" (or "hypabyssal") or "plutonic" (or "abyssal") which formed at greater depths. As might be expected, they show structures intermediate between those of the effusive and the plutonic rocks. They are very commonly porphyritic, vitreous, and sometimes even vesicular. In fact, many of them are petrologically indistinguishable from lavas of similar composition.

Further Information

Get more info on 'Intrusive'.

External Link Exchanges

Do you know how hard it is to get a link from a large encyclopaedia? Well we're different and will prove it. To get a link from us just add the following HTML to your site on a relevant page:

<a href="http://intrusion.totallyexplained.com">Intrusion Totally Explained</a>

Then simply click through this link from your web page. Our crawlers will verify your link, extract the title of your web page and instantly add a link back to it. If you like you can remove the words Totally Explained and embed the link in article text.
As long as your link remains in place, we'll keep our link to you right here. Please play fair - our crawlers are watching. Your site must be closely related to this one's topic. Any kind of spamming, dubious practises or removing the link will result in your link from us being dropped and, potentially, your whole site being banned.